Steal back time when fastening on steel

Limitations of traditional methods

Traditional methods for fastening on steel can be complicated, time-consuming and expensive:

• Welding: can mean grinding the coated steel, employing a certified welder, gaining hot work permits and repainting the area afterwards
• Through bolting: can mean access to both sides of the steel, time-consuming drilling, and small parts such as nuts, washers and bolts that may get dropped or lost
• Clamping: can require access to both sides of the steel, high material costs and periodic maintenance if the clamp is exposed to vibration

The Hilti advantage

With Hilti X-BT blunt tip fastening you drive a stainless steel fastener into a pre-drilled hole in the steel. This means you maintain the corrosion protection, as there is no damage to the coating. Simply drill a pilot hole, fasten a stud and check the embedment. Drill, fasten, check for fastenings in less than 2 mins.

Unlike welding or through bolting, you do not need to prepare the base material or rework it afterwards. This makes the installation much faster, while providing reliable corrosion protection. Any trained operator can do the work, you do not need a certified welder. You also do not require access to both sides of the steel, like you do with through bolting or clamping, so no fingers in tight spaces.

Until recently, you could only drive the X-BT with a powder-actuated tool like a DX 351-BT. However, the new BX 3-BT is battery-powered, meaning no storing or disposing of powder cartridges and less hot work restrictions.

Compared to powder-actuated tools, the BX 3-BT is more comfortable to use thanks to lower compression force, noise and recoil. Plus, you can make up to 800 fastenings, with just a full charge of your existing Hilti 22V Li-ion batteries.